➡️ 𝗚𝘂𝗶𝗱𝗲 -

📍Click on “Start” in the bottom left-hand corner of 𝘀𝗰𝗿𝗲𝗲𝗻

📍Click on “Run”

📍Type in “command” and hit ok

You should now be at an MSDOS prompt screen.

📍Type “ipconfig /release” just like that, and hit “enter”

📍 Type “exit” and leave the prompt

• Right-click on “Network Places” or “My Network Places” on your desktop.

📍Click on “properties” You should now be on a screen with something titled “Local Area Connection”, or something close to that, and, if you have a network hooked up, all of your other networks.

📍Right click on “Local Area Connection” and click “properties”

📍Double-click on the “Internet Protocol (TCP/IP)” from the list under the “General” 𝘁𝗮𝗯

📍Click on “Use the following IP address” under the “General” 𝘁𝗮𝗯

📍Create an IP address (It doesn’t matter what it is. I just type 1 and 2 until i fill the area up).

📍Press “Tab” and it should automatically fill in the “Subnet Mask” section with default numbers.

📍Hit the “Ok” button 𝗵𝗲𝗿𝗲

📍Hit the “Ok” button again You should now be back to the “Local Area Connection” screen.

📍 Right-click back on “Local Area Connection” and go to properties again.

📍Go back to the “TCP/IP” 𝘀𝗲𝘁𝘁𝗶𝗻𝗴𝘀

📍 This time, select “Obtain an IP address automatically” tongue.gif

📍18. Hit “Ok”

📍Hit “Ok” 𝗮𝗴𝗮𝗶𝗻

DONE

    Can I change my IP address to USA?